Gel Printed Badges Using Gelli Arts® Mini Plates by Lucy Brydon

Hi! Lucy here. 

Today I am going to show you a fun way of making little
badges and brooches using gel printed scraps you may have lying around, or you
can print some specially for the project!

Video instructions to follow along:

Start off with making some prints. I used
the hexagon shaped plate, but any will do. I used leaves as that is always my go
to for printing, but again, any prints will do, so use your personal preference!

I layered up several layers of bright
colours using the DecoArt paints.

Once your prints are dry, draw around the
shapes you are going to use for your badges and cut out the shapes.

I used a roll of washi tape just so I could
see what the prints would look like when cut out before I committed to cutting

gel medium or pva glue, attach your prints to the wooden shapes. Let them dry
completely, then trim them with scissors. You can also use some sandpaper to
neaten up the edges.

I am using Sepia Accents to add a
dimensional shiny surface to my badges, but you can also use Diamond Glaze, or
just do a layer of varnish if you do not have those products. If you are adding
a dimensional medium, apply it carefully and use a pin to get rid of any air
bubbles. Let this layer dry completely! It may take a while so be patient!

Finally, once this is dry, attach a brooch
pin to the back using some E6000 glue. 

Let this dry for several hours
(12-24) before using.

We would love to see what you create! Please share on instagram and don’t forget to tag #gelliarts and #gelliartsinspiration ☺

For this project you will need:

  • A mini gel plate (any size will do but the mini ones are good for making small prints)
  • Cardstock or paper
  • Acrylic paints (I used DecoArt acrylic but any will do)
  • Brayer
  • Leaves or other
  • Wooden shapes (I got mine on
  • Dimensional medium – I used
    Sepia Accents but you can also use Diamond Glaze)
  • Glue or gel medium
  • Brooch pins
  • E6000 glue

© 2019 by Gelli Arts®, LLC

Philadelphia, PA All rights reserved.

3 thoughts on “Gel Printed Badges Using Gelli Arts® Mini Plates by Lucy Brydon”

Leave a Reply

%d bloggers like this: